Getting aggregate information

You can display information about the configuration and the state of an aggregate.

Considerations

Step

1. Enter the following command: aggr status [-d] [-r] [-v]
   • With no options, the aggr status command displays a concise synopsis of aggregate states, including:
     • The aggregate name
     • Whether it is an aggregate or traditional volume
     • Whether it is online, offline, or restricted
     • Its RAID type
     • Other states such as partial or degraded
     • Options that are enabled, either by default or through the aggr options or vol options command
     Note: If you specify an aggregate, such as aggr status aggr0, the information for that aggregate is displayed. If you do not specify an aggregate, the status of all aggregates and traditional volumes in the storage system is displayed.
   • The -d option displays information about disks.

     The disk information is the same as the information from the sysconfig -d command.

   • The -r option displays RAID, plex, and checksum information for an aggregate.

     The display is the same as the sysconfig -r display.

   • The -v option displays information about each RAID group within an aggregate or traditional volume, and the settings of the aggregate options.
   Note: You can also get aggregate information, either interactively or with a script, using the stats command.

   For more information about aggregates, see the Data ONTAP Storage Management Guide. For more information about the aggr command, see the na_aggr(1) man page.