Table of ContentsLibraryView in Frames

Setting the privilege level

You set the privilege level to access commands at either the administrative or the advanced level.


  1. Enter the following command: priv set [-q] [admin | advanced]

    admin sets the privilege level to administrative.

    advanced sets the privilege level to advanced.

    -q enables quiet mode. It suppresses the warning that normally appears when you set the privilege level to advanced.

    Note: If no argument is given, the default, admin, is applied.


    Assuming the name of the storage system is sys1, the storage system prompt is sys1>, as shown in the following example.

    sys1> priv set advanced

    The following message is displayed, followed by the advanced mode storage system prompt. Warning: These advanced commands are potentially dangerous; use them only when directed to do so by technical personnel. sys1*>