Table of ContentsLibraryView in Frames

Data ONTAP commands for the RLM

Data ONTAP provides rlm commands that allow you to manage the RLM, including setting up the RLM, rebooting the RLM, displaying the status of the RLM, and updating the RLM firmware.

The following table describes the Data ONTAP commands for the RLM. These commands are also described in the na_rlm(1) man page.
Note: When you enter some of these commands, there might be a pause of a few seconds while the storage system queries the RLM. This is normal behavior.
Data ONTAP Command for the RLM Description
rlm help Displays the list of rlm commands available with the current release of Data ONTAP.
rlm reboot Reboots the RLM and causes the RLM to perform a self-test. Any console connection through the RLM is lost.
rlm setup Initiates the interactive RLM setup program.
rlm status Displays the current status of the RLM.
rlm test autosupport Sends a test e-mail to all recipients specified with the option.
rlm test snmp Performs SNMP test on the RLM, forcing the RLM to send a test SNMP trap to all trap hosts specified in the snmp traphost command. For information on initializing SNMP traps, see the Data ONTAP Network Management Guide.
rlm update Updates the RLM firmware.

For instructions on how to download and update the RLM firmware, see the Data ONTAP Upgrade Guide.

Related concepts
Ways to configure the RLM