Ending SnapVault backups for a qtree

You can use the snapvault stop command to end the SnapVault backup process for a qtree when you no longer need the data in the primary storage system qtree to be protected.

Step

1. From the secondary storage system, enter the following command:snapvault stop [sec_system:]sec_qtree_path

   [sec_system:]sec_qtree_path is the qtree that you no longer want to back up.

   Example

   systemB> snapvault stop systemB:/vol/sv_vol/qtree3

   SnapVault stops updating the qtree on the secondary storage system and deletes the qtree. Existing Snapshot copies on the secondary storage system are unaffected, but as new Snapshot copies replace the old ones, the data from the qtree whose backup was stopped will disappear.

   Note: After you end the backup process from a SnapVault secondary storage system, you might want to release the now-obsolete Snapshot copies on the primary storage system.